Polk Audio RMDS-1 User Manual download pdf (Page 22)

Polk customer service (800) 377-7655

POWER

—

SUB

WOOFER

VOLUME

late

surround

on/off

— radio tuner

night

radio preset +

—

audio

SOURCES

DVDcable-LD

radio

AM preset scan

mute

audio

video/

LD-RF

aux.

DSS digital.

VCR

DSS

multi-room

tape

ON SCREEN MENU

ENTER

delaystatus balance

RM DIGITAL SOLUTION DR-1

COAX1

DIGITAL

STEREOTEST MEMO AUTO

PCM

power ———— standby

source

on/off

surround

multi-room

tune

save

preset

clear

presets

TUNED

OPT NIGHT

PROLOGIC

P-SCANSTEREO

MULTICOAX2

kHz

MHz

DOLBY

DIGITAL

RM DIGITAL SOLUTION

INTELLIGENT A/V PREAMP/PROCESSOR/LOUDSPEAKER SYSTEM

aux. inputs S-video

volume

video L..audio..R

Listening to the radio

1. Press the POWER switch (A) to turn on the power.

2. Press one of the SOURCE buttons (B) on the front panel, or the AM

or FM buttons on the remote (C) to select either the FM or AM band.

3. Press the TUNE UP and DOWN buttons (D) to tune in the desired

station. Pressing once for less than a half second changes the frequency

by one step. Pressing longer sequentially scans frequencies in the

indicated direction. Releasing the button in this state activates the auto

tuning function which automatically scans the frequencies until it

reaches a station, at which point the TUNED and signal level indicators

light and auto tuning stops.

4. Adjust the volume with the VOLUME control (E).

IMPORTANT NOTES ON FM RADIO RECEPTION:

The supplied FM antenna will only allow the tuner to pick up strong

local radio stations. If you want better reception of distant FM

stations you will need a better FM antenna. Your Polk Audio dealer

can recommend a high quality indoor or outdoor FM antenna. Be

sure to get one with a 75 Ohm coaxial output. If you already have a

TV roof antenna, you can use it for the FM tuner. Get a signal splitter

from a radio/TV dealer or Radio Shack store. It will allow you to use

the same antenna for TV and FM radio reception.

If a radio station you select has a lot of background noise or

otherwise sounds distorted, the tuner is not getting a strong

enough signal. Look at the Signal Strength indicator in the upper

left hand corner of the display. If there are three or fewer bars lit,

that means you need to point the antenna in a different direction.

Watch the signal strength meter as you slowly rotate the antenna,

noting which direction gives you the strongest reading on the

meter. If you still don’t get clear reception of the radio station, you

either need a better antenna, or the broadcast station is too far

away from your home for good reception.

HOW TO USE YOUR RM DIGITAL

SOLUTION SYSTEM

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments

Polk Audio RMDS-1 User Manual Page 22

Comments to this Manuals

Related products and manuals for Speaker sets Polk Audio RMDS-1