Polk-audio LSiM User Manual download pdf (Page 12)

12 Polk Audio Customer Service: 1-800-377-7655 (Outside US & Canada: +1 410-358-3600) Monday-Friday, 9:00 AM-5:30 PM EST, [email protected]

Rubber Feet & Adjustable Floor Spikes

Rubber feet and adjustable floor spikes are included

with your LSiM floorstanding loudspeakers to anchor

and stabilize the speaker on any type of floor. However,

you may wish to tilt the speaker backwards or forward

a tiny bit in order to optimize your listening area. This

is a subtle change you can experience that optimizes

imaging in your setup.

To Adjust The Floor Spikes

The floor spikes can be adjusted with the use of the

supplied 5 mm hex (Allen) wrench. Most floorstanding

speakers are adjustable only from below and require

two hands. The LSiM floor spikes are adjustable

from above.

Note: If the speaker is stable on the floor, no adjustment

is necessary.

If the speaker is unstable, follow these steps:

1. The speaker will be inclined to settle on three of the

four spikes leaving one spike slightly off the floor.

2. Determine which spike needs to be adjusted.

3. Use the supplied hex wrench and turn it clockwise

to lower the spike or counterclockwise to raise it.

4. The threaded portion of the spike is coated with

a locking compound, so the spike may offer some

resistance when you turn it.

5. As the spike contacts the floor, it will become

more difficult to turn. At that point the speaker

should be stabilized.

LSiM Floor SpikeLSiM Rubber Foot

Adjusting Floor Spike with Supplied

Hex (Allen) Wrench

Clockwise to raise

Counterclockwise

to lower

Removing Rubber Feet

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Polk-audio LSiM User Manual Page 12