Polk Audio DP-1 User Manual download pdf (Page 35)

www.polkaudio.com

Erasing All the Learned Commands

in All Device Modes

This procedure will erase all the learned commands on all the buttons

in all eight Source/Device modes. Be really, really sure you want to do

this before following the steps below.

1. Press and hold the LEARN button for two seconds.

The Status light at the top left of the remote will glow orange.

2. Press and hold the LEARN button again for 10 seconds. The

Status light will flash red continuously. The status light will then

flash green once, orange once then turn off, indicating that all of

the learned commands in all of the Source/Device modes on the

remote control have been erased.

Restoring Factory Programming

If you want to restore the DR-3 to it’s original programming and oper-

ation, press the LIGHT and POWER buttons simultaneously for 10

seconds. The red status light will blink while the remote is resetting.

It will confirm the reset by blinking green and then orange.

PROGRAMMING THE REMOTE

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 45 46

No comments

Polk Audio DP-1 User Manual Page 35